Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Convergence problem near boundary, two phase flow, level-set method

Please login with a confirmed email address before reporting spam

Hi everyone. I'm working with droplet ejection. The droplet have the density and viscosity of water and the sorrounding fluid, density and viscosity of air. To solve it i'm using the level-set method.

There is no problem with the ejection, but when the drop reaches the boundary that it has to cross, the time step start going down and finally the solver stops.

I've changed that boundary conditions several times, i tried:

Outlet: Normal stress (f=0)

Open boundary: No viscous stress

Open Boundary: Normal stress (f=0)

But in every case the solution reaches the same problem when the droplet tries to pass trough that boundary.

What can i do to avoid this convergence in the boundary? what boundary condition should i use to avoid this problem?

I'm attaching an image of what i'm saying,


Thanks for the help!


0 Replies Last Post 15.04.2013, 11:17 GMT-4
COMSOL Moderator

Hello Alfonso Santiago

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.