Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

boundary layer meshing ?

Posted 29.03.2013, 06:28 GMT-4 1 Reply

Lukas Alberts
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam


Hello,

why is the boundary meshing interrupted in the corner of 2 edges?
(attached pictures)

These are the limits of my plasma reactor. The point where my electrical feedthrough is, ceramic/metal joint.
The point where all happens?).
So why is there the mesh not like a bit further away, where the boundary meshing is on both side of the edges?

in 3.5, I could prevent comsol from meshing inactiv domains.. I am doing something wrong (the inside of metals do not bother me..)

Thanks

Lukas
nagoya-u
1 Reply Last Post 29.03.2013, 07:10 GMT-4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 29.03.2013, 07:10 GMT-4
Hi

strange, it could be from some BC that turns them, off, but if the boundaries are all in the list of the boundary mesh definition they should be meshed. Probably only Support might be really able to tell here ;)

--
Good luck
Ivar
Hi strange, it could be from some BC that turns them, off, but if the boundaries are all in the list of the boundary mesh definition they should be meshed. Probably only Support might be really able to tell here ;) -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content