Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Model conversion from 2d axi to regular 2d

Posted 13.03.2013, 04:08 GMT-4 Version 4.2 2 Replies

mb
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear community,

I want to convert a 2d axisymmetric model into a regular 2d model.

Is that possible or do I need to setup the model again in 2d?


Many thanks,
Marcel
2 Replies Last Post 13.03.2013, 04:59 GMT-4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 13.03.2013, 04:56 GMT-4
Hi

you need to set up the model again, but it's quickly done, you can save and reload the geometry, variables and parameters, and then open 2 COMSOl and cut & paste from one into the other

--
Good luck
Ivar
Hi you need to set up the model again, but it's quickly done, you can save and reload the geometry, variables and parameters, and then open 2 COMSOl and cut & paste from one into the other -- Good luck Ivar
mb
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 13.03.2013, 04:59 GMT-4
Thanks for the prompt answer :)
Thanks for the prompt answer :)

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content