Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Prolonged error with "Last Time Step Not Converged"
Posted 13.03.2013, 00:40 GMT-4 Fluid & Heat, Heat Transfer & Phase Change, Computational Fluid Dynamics (CFD), Results & Visualization, Studies & Solvers Version 4.3a 0 Replies
Please login with a confirmed email address before reporting spam
We were trying out "PIPE FLOW MODULE" as you have suggested. And thanks for the advice, as it has reduced the number of mesh elements to a larger extent. But, we were getting a consistent error message namely,
"Error:
Failed to find consistent initial values.
Segregated group 2
COMSOL assertion failure.
Last time step is not converged.
Warning:
SOR line did not find any lines. "
I would like you to verify our model and help us if any errors made in the modeling.
Basic parameters are that, the heat flux will take place in walls through inner air, atmospheric air and water in pipes as in the model. I would be so grateful, if our prolonged error is sorted out.
Attachments:
Hello Nithin Kumar Peratla
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.