Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Compressible and transient flow problem
Posted 27.02.2013, 11:22 GMT-5 Fluid & Heat, Computational Fluid Dynamics (CFD), Microfluidics Version 4.3a 1 Reply
Please login with a confirmed email address before reporting spam
Hi,
I am trying to model a tank full of air that empties with time through a thin channel (It is almost a nozzle). I used the laminar-transient formulation. I chose from the library the properties of air. I selected the compressible formulation, with a mapped mesh for fluid mechanics (20000 elements), and I chose a time step of (0,0.01,2). The program is in 1% after 1 day of computation.
Any clues of how can I improve my model to get it done faster? This is a 2D model (axisymmetric formulation) ,and it surprises me that is taking toolong. Should I use the microfluidics module for this case? Should I modify the time step? In the boundary conditions the model has an initial pressure, and the nozzle has the open boundary condition. I am looking forward to finding the time that takes to empty this tank.
Attached is my model
Thanks
I am trying to model a tank full of air that empties with time through a thin channel (It is almost a nozzle). I used the laminar-transient formulation. I chose from the library the properties of air. I selected the compressible formulation, with a mapped mesh for fluid mechanics (20000 elements), and I chose a time step of (0,0.01,2). The program is in 1% after 1 day of computation.
Any clues of how can I improve my model to get it done faster? This is a 2D model (axisymmetric formulation) ,and it surprises me that is taking toolong. Should I use the microfluidics module for this case? Should I modify the time step? In the boundary conditions the model has an initial pressure, and the nozzle has the open boundary condition. I am looking forward to finding the time that takes to empty this tank.
Attached is my model
Thanks
Attachments:
1 Reply Last Post 28.02.2013, 01:59 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
I believe its a "mesh issue", but as you have deleted the mesh structure one cannot tell how it was or should be (its enough to do a Edit Clear All Solutions - Clear all mesh File reset history) to make your file light and uploadable
I would advise to fillet slight the entry of your thin tube, now you will get a singularity on that sharp edge
--
Good luck
Ivar
I believe its a "mesh issue", but as you have deleted the mesh structure one cannot tell how it was or should be (its enough to do a Edit Clear All Solutions - Clear all mesh File reset history) to make your file light and uploadable
I would advise to fillet slight the entry of your thin tube, now you will get a singularity on that sharp edge
--
Good luck
Ivar