Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Setting temperature initial condition at specific location

Please login with a confirmed email address before reporting spam

Hello,

I'm trying to solve a porous media heat transfer problem. the geometry of the problem includes 10/200 meters rectangle, where I'm setting a linear temperature gradient by the following equation:

T=((10[m]-y)/10[m])*100 [K]+293.15[K]

which works fine, next I need to set at the middle node of the rectangle (at location x=100, y=5) a temperature perturbation different from the value imposed by the equation.

How do I do that?

I Hope I'm explaining myself well.

Best Regards

0 Replies Last Post 06.02.2013, 11:53 GMT-5
COMSOL Moderator

Hello Roi Roded

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.