Negligible pressure boundary loads are giving non-physical displacements

Please login with a confirmed email address before reporting spam

Hi all,

I am a new comsol user, and am getting started with a very simple solid mechanics modeling problem. Here is the basic setup:

  • Rotationally symmetric steel shell with 1.0 m and 0.5 m outer and inner radii respectively. The Young's modulus is 200 GPa, and the Poisson ratio is 0.3.
  • The boundary load on the outside boundary is P_1 = 10 Pa.
  • The boundary load on the inside boundary is P_2 = 1 Pa.
  • Solve for the equilibrium stress tensor and displacements.

I am attaching the .mph file for this problem. This particular problem is analytically solvable. For such a small pressure difference, the displacement of the outer boundary should be tiny. When I solve, I see this is actually the case. One of the attached plots is the calculated displacement along the radial direction. The reported displacement is negligible.

displacement.png

However, when I display the 2D and 3D models of the stress, it looks like the whole model has been compressed by 20 cm in the radial direction (see attached figure). When I set P_1 = P_2 = 0, there is no compression (but also no stress field), however any nonzero pressure difference is giving me these crazy nonphysical distortions of the body.

stress.png

What am I doing wrong here!



1 Reply Last Post 30.08.2024, 10:31 GMT-4
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 3 months ago 30.08.2024, 10:31 GMT-4
Updated: 3 months ago 30.08.2024, 11:01 GMT-4

Hello True,

Good news: You are not doing anything wrong. The deformations are scaled in that plot; the scaling factor is chosen automatically such that the deformations are visible to our naked eye. Change that scaling factor to 1 if you want them represented at their real magnitude - but of course you will no longer see them because they are very very very small.

Jeff

-------------------
Jeff Hiller
Hello True, Good news: You are not doing anything wrong. The deformations are scaled in that plot; the scaling factor is chosen automatically such that the deformations are visible to our naked eye. Change that scaling factor to 1 if you want them represented at their real magnitude - but of course you will no longer see them because they are very very very small. Jeff

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.