Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Heat removal boundary condition
Posted 14.01.2013, 05:11 GMT-5 Low-Frequency Electromagnetics, Heat Transfer & Phase Change 1 Reply
Please login with a confirmed email address before reporting spam
I have to simulate induction heating phenomena of a cylinder in 2D with a Cooling arrangement inside the same cube that ( cooling tube arrangement are not visible in 2D ) through a coil so the heat generated is compensated through cooling thus preventing the cube to be overheated.
Simpy, If I want to define 30 % of the heat loss from the heat produced inside a work piece then how It could be possible.
--
ishant.jain@tatasteel.com
Simpy, If I want to define 30 % of the heat loss from the heat produced inside a work piece then how It could be possible.
--
ishant.jain@tatasteel.com
1 Reply Last Post 14.01.2013, 09:49 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi Ishant,
You can setup an Integration Model Coupling variable to be the total heat produced in the part. However, if the heat loss is always 30% of the heat produced the part will heat up indefinitely. If you use a convection boundary condition to represent the cooling arrangement that will be better since the heat loss will scale with temperature.
Nagi Elabbasi
Veryst Engineering
You can setup an Integration Model Coupling variable to be the total heat produced in the part. However, if the heat loss is always 30% of the heat produced the part will heat up indefinitely. If you use a convection boundary condition to represent the cooling arrangement that will be better since the heat loss will scale with temperature.
Nagi Elabbasi
Veryst Engineering