Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Distance between two points
Posted 14.12.2012, 08:47 GMT-5 1 Reply
Please login with a confirmed email address before reporting spam
Hi !
Suppose I put two circles at position (0,0) and (0,2). If I rotate the second circle with respect to first(0,0) at a range (0,60,360), it gives a hexagon.Is there any way to confirm the distance between centre and other points surrounding it are same.If I measure it by point measurement then it gives wrong result.Please help me in this regard.I am using COMSOL 4.3.151.Thank you.
Suppose I put two circles at position (0,0) and (0,2). If I rotate the second circle with respect to first(0,0) at a range (0,60,360), it gives a hexagon.Is there any way to confirm the distance between centre and other points surrounding it are same.If I measure it by point measurement then it gives wrong result.Please help me in this regard.I am using COMSOL 4.3.151.Thank you.
1 Reply Last Post 14.12.2012, 09:38 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
normally you should get the same value, what I suspect is that the picking of the points are not perfect, you have also the snap to grid on/off issue.
You cannot really tell from the graphics view where you points are, you can generate points by intersecting lines and getting COMSOL to make the intersection points when you analyse the geometry via the geometry finish node, but you are also linked to the geometry and "finish" tolerances tolerance
I tried to generate lines by using the built-in snap function, the results are small deviations around 1E-4, but if I use trigonometric analytical functions to define my points, I'm getting measured values precise to the correct number of digits
--
Good luck
Ivar
normally you should get the same value, what I suspect is that the picking of the points are not perfect, you have also the snap to grid on/off issue.
You cannot really tell from the graphics view where you points are, you can generate points by intersecting lines and getting COMSOL to make the intersection points when you analyse the geometry via the geometry finish node, but you are also linked to the geometry and "finish" tolerances tolerance
I tried to generate lines by using the built-in snap function, the results are small deviations around 1E-4, but if I use trigonometric analytical functions to define my points, I'm getting measured values precise to the correct number of digits
--
Good luck
Ivar