Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
1D plot of some points
Posted 06.12.2012, 15:19 GMT-5 1 Reply
Please login with a confirmed email address before reporting spam
Hi everybody,
I have one problem in my model:
I want to plot(1D POINT PLOT) the temperature of some points but if that point is not a node i don't know how to select it..
The geometry and the points i want to plot the temperature are in the picture.
I have one problem in my model:
I want to plot(1D POINT PLOT) the temperature of some points but if that point is not a node i don't know how to select it..
The geometry and the points i want to plot the temperature are in the picture.
Attachments:
1 Reply Last Post 06.12.2012, 15:50 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
either you create some points in your geoemtry and forces the mesh to place some nodes that you might pick (or you make edges or surfaces intersect yt your points (this adds some internal boundaries).
But you might also use the Results Data-Set cut sorface, cut edge cut point feature to define some specific location and have COMSOL interpolate the results onto these locations, then you can select these Data-Sets for your plots
--
Good luck
Ivar
either you create some points in your geoemtry and forces the mesh to place some nodes that you might pick (or you make edges or surfaces intersect yt your points (this adds some internal boundaries).
But you might also use the Results Data-Set cut sorface, cut edge cut point feature to define some specific location and have COMSOL interpolate the results onto these locations, then you can select these Data-Sets for your plots
--
Good luck
Ivar