Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Co-simulation between simscape (simulink) with comsol
Posted 06.12.2023, 10:34 GMT-5 Interfacing, LiveLink for Simulink 0 Replies
Please login with a confirmed email address before reporting spam
Hi, I just need some advise on the model I built below. Is there anything wrong with the connection? My plan is to see the current flowing through the comsol model and also the resistors branch when I change electrical conductivity of my electrical tree. The comsol model is a needle-plane dieletric 3D model with an electrical tree.
I have no idea how to connect the ammeter to the comsol block to monitor it's current so I just put one across the resistors branch.
I noticed that no changes to the current eventhough I changed the conductivity of my tree in comsol. I used the electrical current study to reflect the conductivity changes.
So can someone advise what correction i should make to my simscape circuit.
Thanks.
Attachments:
Hello Nor Faezah Binti Adan
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.