Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
On Mapping Mesh Division of Double Electric Layer Direction
Posted 19.07.2023, 08:29 GMT-4 Computational Fluid Dynamics (CFD), Microfluidics, Mesh 0 Replies
Please login with a confirmed email address before reporting spam
I want to draw a mapping mesh in this model, and the requirements are as follows: A mapped mesh with M uniform points along the azimuthal direction and N points along the radial direction is used in the simulation.（M=1200,N=500）the total number of mesh elements is chosen to be 600 000 in the current study. To resolve the detailed information of EDL,extremely fine meshes were created near the cylinder surface.The smallest mesh size near the cylinder surface is 1% ofthe Debye length(Debye length is 0.1nm) and then increases by 3% away from the cylinder. Do you have any good suggestions? Do I need to draw a mesh inside of the circle? My method is like this（2.png、3.png）. Is it correct？
Hello Tao Zhou
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.