Discussion Forum

Forum Home

New Discussion

Note: This discussion is about an older version of the COMSOL Multiphysics^® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to set the time step dt to a specific value when calculating for transient problem

Posted 03.11.2012, 04:05 GMT-4 Version 4.3 2 Replies

Nhat Nam Nguyen

Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello everybody,
I am now simulating a transient problem using Electric current mode but I do not know how to set up the time step dt to a specific value. Anybody have experiences about this, please help me.
Thank you very much.
Nam

2 Replies Last Post 05.11.2012, 21:45 GMT-5

Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago

Hi

you define the time stepping in the time dependent solver node, COMSOl will choose it's own stepping and save the results at your difined time steps, by default, you can chenge these settings down in the solver sub-nodes

--
Good luck
Ivar

Nhat Nam Nguyen

Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago

Dear Mr. Ivar,
Thank you very much for your response.
Best Regards,
Nam

Note that while COMSOL employees may participate in the discussion forum, COMSOL^® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Discussion Forum

How to set the time step dt to a specific value when calculating for transient problem

Suggested Content