Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Two phase laminar flow - Level Set Method : Extracting interface and using it as a probe
Posted 15.08.2022, 04:19 GMT-4 General, Microfluidics, Modeling Tools & Definitions Version 5.6 0 Replies
Please login with a confirmed email address before reporting spam
I am using the two phase laminar fow - level set method to study (2D) a water droplet in air medium subject to certain forces. I want to extract the x,y coordinates of the interface (i.e. level = 0.5), at each simulation step, and ultimately use them as a probe. How should I do this (as it is not a generic probe like avg/max/min etc.)?
P.S. This is different from post-processing where I can simply plot the contour corresponding to the level = 0.5 for the interface.
Hello SNIreaPER
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.