Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Error message

Please login with a confirmed email address before reporting spam

HI there,
I am running a simulation under transient state to get the magnetic flux density for a generator. Under static condition its ok. But not under tansient state. The error message is as follows:
Error:
Time 0.00365:
Nonlinear solver interrupted since convergence rate above limit.
Last time step is not converged.

Can anyone advise me where I have gone wrong.

Thank you.

0 Replies Last Post 07.02.2010, 19:16 GMT-5
COMSOL Moderator

Hello Amissa Arifin

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.