Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Time steps decrease abruptly after stopping a time dependent simulation

Posted 14.10.2021, 07:52 GMT-4 Electromagnetics, Low-Frequency Electromagnetics Version 5.6 1 Reply

Aki
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi, I am using magnetic field(mf) simulation. I find every time I continue a study after stop and saving it, the time steps will decrease greatly compared to the steps before I stop it. The simulation becomes too slow to output a solution due to the tiny steps. Are there any solutions to improve the situation?

1 Reply Last Post 14.10.2021, 10:10 GMT-4
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 3 years ago 14.10.2021, 10:10 GMT-4

Hello Aki,

This Knowledgebase entry explains how the transient solver selects the initial time step size and discusses how you can affect the time step size by adjusting solver settings. I think this will answer your question.

Best,

Jeff

-------------------
Jeff Hiller
Hello Aki, This [Knowledgebase entry](https://www.comsol.com/support/knowledgebase/1254) explains how the transient solver selects the initial time step size and discusses how you can affect the time step size by adjusting solver settings. I think this will answer your question. Best, Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content