Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

coupling electrostatic model and model electric circuit

Posted 31.05.2012, 09:25 GMT-4 Low-Frequency Electromagnetics Version 4.2 1 Reply

Med Amin
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi

is that one can apply a sinusoidal voltage of the CIR model on a terminal of the electrostatic model?

thank you
1 Reply Last Post 31.05.2012, 15:27 GMT-4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 31.05.2012, 15:27 GMT-4
Hi

you cannot link ES to an CIR AC source, but you can link it to a CIR Sinus source, the AC source are for Frequency domain solvers and ES is not set up for harmonic solving ES=Electro-Static and not Dynamic ;)

But why use a CIR ? you can as well define a V0*sin(2*pi*Freq*t[1/s]) as terminal or Electric Potential within ES

--
Good luck
Ivar
Hi you cannot link ES to an CIR AC source, but you can link it to a CIR Sinus source, the AC source are for Frequency domain solvers and ES is not set up for harmonic solving ES=Electro-Static and not Dynamic ;) But why use a CIR ? you can as well define a V0*sin(2*pi*Freq*t[1/s]) as terminal or Electric Potential within ES -- Good luck Ivar

Attachments:

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content