Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Releasing a particle at arbitrary point of the inlet surface
Posted 31.05.2012, 04:52 GMT-4 Charged Particle Tracing, Fluid & Heat, Computational Fluid Dynamics (CFD), Particle Tracing for Fluid Flow Version 4.2a, Version 4.4 2 Replies
Please login with a confirmed email address before reporting spam
I'm simulating a laminar fluid flow through a channel with structures on the bottom. When I use particle tracing module the release options are 'mesh based', 'density' and 'projected plane grid'.
I'd like to know if there is a possibility to specify a single point of release at the inlet, so something like 'a start point controlled' release.
Thank you very much for your help!
Hello Izidor Sabotin
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
I would like to do the same thing.
I'd like to know if there is a possibility to specify a single point of release at the inlet.
Did you find a solution?
Thank you!
Please login with a confirmed email address before reporting spam
I haven't found the solution. I think in general you have 3 options:
- mesh based,
- density based,
- projected plane grid
Try to play on with those options, or find the user manual. I think there should be one option that enables this.
Sorry I couldn't help more, hope you will successfully resolve your thig.
Best of luck,
Izidor