Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Interpolation inconsistencies comsol!
Posted 10.03.2021, 10:59 GMT-5 1 Reply
Please login with a confirmed email address before reporting spam
Dear ALL,
I am performing thermo-elastic analyisis of a material. I have the following temperature change: time (h) T(deg C) 0 20+273.15 3 -5+273.15 12 -20+273.15 16 -20+273.15 24 20+273.15 I am entering it as an interpolation function. Unfortunately I have a stress jump at 3 h (see figure) where there a change in temprature (table). i dont know how to overcome this artefact that i think is related to temperature interpolation. when I zoom on the t=3h the linear interpolation line is not passing through this coordinate.
A cubic wise interpolation gives beteter results but the created tmeprature cycle is not very accurate.
Any suggestions for a better interpolation?
Attachments:
Please login with a confirmed email address before reporting spam
Hello Sarab,
I suspect that it is just a sampling effect that causes your interpolation function to appear not to be going through the value you specified, see this thread for a discussion of that effect.
Best,
Jeff
-------------------Jeff Hiller