Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to set the pressure of vacuum in the SPF module

Posted 27.04.2012, 11:11 GMT-4 0 Replies

Michal Challi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

HeIIo,everyone. I'm new to comsol and recently I' m simulating the gas into a chamber through a long hollow fiber.I choose the SPF module and the initial condition of the system is vacuum.The inlet conditon is constant pressure inlet and I want to get the time-dependent chamber pressure.Now the problem is that at the setting of the fluid properties , if I set the Pre=1[atm] I can get the result but not correct;if disable the Pre or set the Pre a very low pressure,comsol presents the mod.p isn't defined.So I want to konw how to set the pressure of vacuum.Your comments and answers are welcomed and appreciated.Thank you.
0 Replies Last Post 27.04.2012, 11:11 GMT-4
COMSOL Moderator

Hello Michal Challi

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content