Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Moving steel in the air problem.

Posted 05.04.2012, 11:29 GMT-4 Version 4.2 0 Replies

JiYoung Park
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi, I want to simulate moving down steel in the air.

It is transient problem and I added laminar flow and moving mesh module.

The geometry is like the file I attached.

I set the whole geometry as free deformation and

set just the steel boundaries as prescribed mesh velocity of 1cm/s.

However I found that the mesh at the both side were not moved down to break the mesh.

I think it may be from bad boundary condition.

Please help.

Thanks.

Attachments:

0 Replies Last Post 05.04.2012, 11:29 GMT-4
COMSOL Moderator

Hello JiYoung Park

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content