Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Heat Transfer in 3D Metal Powder

Please login with a confirmed email address before reporting spam

I have been trying to simulate the heat transfer in 3D Metal Powder. However, after I set a boundary heat source at one section of the sphere (there are 8 sections in total), COMSOL told me I didn't have an consistent initial value. Do you know why?

Many thanks


0 Replies Last Post 22.07.2020, 07:28 GMT-4
COMSOL Moderator

Hello Jieming Zhang

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.