Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
How to make a omega shape in comsol using 3D geomety
Posted 08.06.2020, 20:09 GMT-4 Low-Frequency Electromagnetics, Geometry, Modeling Tools & Definitions Version 5.2a 1 Reply
Please login with a confirmed email address before reporting spam
Hi, I am trying to make a microstrip line with a omega shape in the center of the wire. I tried using a rectangular block and then added another block to it but I cannot bend the lines or add a circle(because I am in 3D geometry) to make an omega shape. I am new to COMSOL so any help is appreciated. Thanks.
Please login with a confirmed email address before reporting spam
Hello Ayesha,
You will find training videos on how to create geometries in COMSOL in the Learning Center. If you still need help after watching those videos, it would be helpful to Discussion Forum users if you could post a sketch of the shape you are trying to create.
Bet regards,
Jeff
-------------------Jeff Hiller