Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to get a voltage source in Comsol

Posted 11.01.2012, 20:41 GMT-5 Low-Frequency Electromagnetics Version 4.0a 0 Replies

Gustavo Leite Silvano
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello everybody,
I'm new in using Comsol 4.0a, so this may be a simple question, but it will be very usefull if anyone answer me.
So I want to simulate an dipole with a voltage source in the middle of them, but I don't know what's the correct way to do it.
The model that i'm using is AC/DC module, and eletrostatic. So I don't know if I may use an eletric potencial in a point or in the ends of the conductor. If it's in a point, I just put a +1V voltage in the point, or I have to define a ground too? If it's in the ends of the conductor, I've to define a +1V and a -1V, or just two +1V?
I'm attaching an sketch of the model.

THanks

Attachments:

0 Replies Last Post 11.01.2012, 20:41 GMT-5
COMSOL Moderator

Hello Gustavo Leite Silvano

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content