Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Stress linearisation along any arbitrary path

Posted 31.10.2019, 07:55 GMT-4 Structural & Acoustics, Mesh, Structural Mechanics 2 Replies

Abhishek Basak
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello, I wonder if there is a means to do stress linearisation during post processing along any arbitrary path intersecting the structure? The existing stress linearisation node allows selection of only predefined edges. Abhishek

2 Replies Last Post 04.11.2019, 01:05 GMT-5
Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 01.11.2019, 02:59 GMT-4
Updated: 5 years ago 01.11.2019, 02:59 GMT-4

Hi Abishek,

Stress linearization requires a geometrical line. If it is problematic to insert a new line, for example because you have a large complex geometry or that the solution takes a long time, then a good idea is to use one or more submodels for the stress linearization evaluations.

How to set up submodels is shown in for example: https://www.comsol.com/model/submodeling-analysis-of-a-shaft-20359 https://www.comsol.com/model/submodel-in-a-wheel-rim-8517

Regards,
Henrik

-------------------
Henrik Sönnerlind
COMSOL
Hi Abishek, Stress linearization requires a geometrical line. If it is problematic to insert a new line, for example because you have a large complex geometry or that the solution takes a long time, then a good idea is to use one or more submodels for the stress linearization evaluations. How to set up submodels is shown in for example: Regards, Henrik
Abhishek Basak
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 04.11.2019, 01:05 GMT-5

Dear Henrik,

Thank you for the reply. I am quiete surprised that COMSOL being such a user friendly software doesn't provide this crucial tool (as far as pressure vessel design is concerned), while softwares like ABAQUS and ANSYS provide such a functionality since a long time.

Is there any add-in which can do the stress linearisation after the stresses have been extracted using cut line 3D option?

Regards Abhishek

Dear Henrik, Thank you for the reply. I am quiete surprised that COMSOL being such a user friendly software doesn't provide this crucial tool (as far as pressure vessel design is concerned), while softwares like ABAQUS and ANSYS provide such a functionality since a long time. Is there any add-in which can do the stress linearisation after the stresses have been extracted using cut line 3D option? Regards Abhishek

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content