Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Unknown dependent state component when using mass flow rate

Posted 24.11.2011, 15:36 GMT-5 Computational Fluid Dynamics (CFD), Studies & Solvers Version 4.2a 0 Replies

J
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

when I run a simulation using the Laminar Flow or Turbulent Flow interface and I use as inlet boundary condition a mass flow rate, under Dependent Variables (under the Study node) I get a new state component called Pmfinl1. Does anyone know the meaning of it? And in general the meaning of "State"?

Best,
J
0 Replies Last Post 24.11.2011, 15:36 GMT-5
COMSOL Moderator

Hello J

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content