Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Problem on Parametric sweep
Posted 17.11.2011, 03:58 GMT-5 Low-Frequency Electromagnetics, Studies & Solvers Version 4.2 1 Reply
Please login with a confirmed email address before reporting spam
Hi,
I have a problem on parametric sweep. I have two electrodes on a block by which to inject a current. I would like to vary the distance between the electrodes, but i lose the reference current on the electrode.
How can I fix it?
I hope i was clearly and i hope in your response.
Thank you so much.
Chiara
I have a problem on parametric sweep. I have two electrodes on a block by which to inject a current. I would like to vary the distance between the electrodes, but i lose the reference current on the electrode.
How can I fix it?
I hope i was clearly and i hope in your response.
Thank you so much.
Chiara
1 Reply Last Post 17.11.2011, 07:19 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
if you make a full parametric sweep (outer loop, not a "continuation") then you can drive your geometry with the parameter that could be deciding on the electrode distance.
Note that in this case each simulation start from original initial conditions, you do not use previous initial conditions as starting point for the next seep value
--
Good luck
Ivar
if you make a full parametric sweep (outer loop, not a "continuation") then you can drive your geometry with the parameter that could be deciding on the electrode distance.
Note that in this case each simulation start from original initial conditions, you do not use previous initial conditions as starting point for the next seep value
--
Good luck
Ivar