Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Edges are too close in 2D domain

Please login with a confirmed email address before reporting spam

Hi, I have some troubles while defining 3D geometry from 2D work plane.

The error message was "Edges are too close in 2D domain"

and it was from "Form Union" section.

Would you please help?

Thanks

2 Replies Last Post 12.09.2013, 11:07 GMT-4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 16.11.2011, 10:41 GMT-5
Hi

check the "relative repair tolerance" tab in the "geometry" window, I cannt find back the second tolerance dimension, perhaps it has disappeared, not being used, in the new 4.2a ;)

--
Good luck
Ivar
Hi check the "relative repair tolerance" tab in the "geometry" window, I cannt find back the second tolerance dimension, perhaps it has disappeared, not being used, in the new 4.2a ;) -- Good luck Ivar

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 12.09.2013, 11:07 GMT-4

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.