Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Seals

Posted 15.11.2011, 11:50 GMT-5 Structural Mechanics Version 3.5a 0 Replies

Gary Ren
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I have a seal which installed into a groove. The width of groove is narrower than the seal's. So there are interferences on both inside and outside lips of seal. The seal and groove is a round ring. So I used an 2D axisymmetrical modeling. For some reason I can get convergence of result. Please help.

Thanks
Gary

Attachments:

0 Replies Last Post 15.11.2011, 11:50 GMT-5
COMSOL Moderator

Hello Gary Ren

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content