Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

heat penetration in microwave oven domain through waveguide

Please login with a confirmed email address before reporting spam

The below post is related to an archived discussion


[start here]sir, As I am done with modelling for basic model (heating of water), i came across two problem 1. the study part showing no output as heating of water in jar domain(domain 2) . Even whenever i selecting the 'domain of oven'(domain 1) then 'jar containingwater'(domain 2) inside it is automatically selected. So the boundary condition on boundary of jar is automatically selected as perfectly conductor. and when i adding physic of "heat transfer in solid", after selecting the jar as my domain , its selected as thermal insulator on a same boundary of my jar.

  1. whenever i have been passing energy through waveguide , it is not been able to go into the microwave oven domain. what shold i do to sort out this problem. please guide me as im new learner to comsol. i am attaching my comsol file , please check out where i gone wrong.


2 Replies Last Post 29.08.2019, 10:14 GMT-4

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 05.08.2019, 16:59 GMT-4
Updated: 5 years ago 05.08.2019, 16:59 GMT-4

See the attached model file with my edits for mw heating

See the attached model file with my edits for mw heating

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 29.08.2019, 10:14 GMT-4

sir, you have not attached any file. please kindly attached it so that i can get some clue.

sir, you have not attached any file. please kindly attached it so that i can get some clue.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.