Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Meshing interpolated curves

Posted 14.06.2019, 11:21 GMT-4 RF & Microwave Engineering, Mesh Version 5.3 1 Reply

Damian Rivas
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I have a simulation where my geometry is an interpolated curve. The meshing for that feature is really fine and detailed:

https://i.imgur.com/V8RDmKw.png

zoomed in:

https://i.imgur.com/o7YLIr8.png

Are there any tricks I can use to reduce the required meshing? Even if it lowers the simulation accuracy, I'm willing to do quicker runs and then more thorough simulations once I'm in the ballpark.

I'm running 5.3 by the way.

Thanks!

1 Reply Last Post 14.06.2019, 11:30 GMT-4
Damian Rivas
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 14.06.2019, 11:30 GMT-4
Updated: 5 years ago 14.06.2019, 11:30 GMT-4

Okay so the "Remove Details" feature helped a lot. Cut down my mesh size by 30%.

https://i.imgur.com/1eDQzXt.png

I will still welcome any tips of course. :-)

Okay so the "Remove Details" feature helped a lot. Cut down my mesh size by 30%. https://i.imgur.com/1eDQzXt.png I will still welcome any tips of course. :-)

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content