Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Beam Uncurling

Please login with a confirmed email address before reporting spam

I have a curved beam that I am attempting to uncurl by keeping one end in place with a prescribed displacement) and applying a prescribed displacement on one point on the other end which should move it into an uncurled configuration. However, the model will not complete the full displacement (several millimeters in the x and y directions) and stops after about 0.2 mm displacement. Any suggestions are appreciated.



0 Replies Last Post 09.05.2019, 16:58 GMT-4
COMSOL Moderator

Hello Allison

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.