Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Is it possible to have a symmetry along pipes when using Pipe Flow Module?

Please login with a confirmed email address before reporting spam

Hi all, I'm making a model of u-tube inside a cylinder by using Pipe Flow Module. The model is symmetric along the cylinder and tube length, but I could not make the symmtry BC to include the pipe (because it is lines in 3D). Thanks for your help.


0 Replies Last Post 05.04.2019, 16:21 GMT-4
COMSOL Moderator

Hello Ahmad Aljabr

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.