Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Bézier polygon within an 2D -> 3D extruded block

Posted 17.10.2011, 10:44 GMT-4 Fluid & Heat, Geometry, Modeling Tools & Definitions, Parameters, Variables, & Functions Version 4.0 0 Replies

LiWah Wong
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

hi

I extruded a 3D block out of a 2D workplane, and then integrated a Bézier polygon into it,

= mesh =
I did free tetrahedral mesh to the 3D block and edge mesh to the Bézier polygon

= Darcy's Law =

I failed to apply '(edge) mass flux' to the Bézier polygon, may I know the error I have made up to here?

many thanks in advance!!

regards
Liwah
0 Replies Last Post 17.10.2011, 10:44 GMT-4
COMSOL Moderator

Hello LiWah Wong

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content