Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Selective meshing

Posted 21.09.2011, 20:02 GMT-4 Version 4.2 1 Reply

Kumar
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam


Hi,

After meshing the geometry using an extremely fine mesh, I would like to further increase mesh density in certain regions like the inlet and outlet of a microfluidic channel.

Can I do this in COMSOL 4.2?

I also want to use custom lines to plot 2D line graphs across the channel after I obtain the results.

How do I do this?

1 Reply Last Post 22.09.2011, 01:57 GMT-4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 22.09.2011, 01:57 GMT-4
Hi

check the doc on mesing, you also have the mesh refinement nodes in v4, just as you can add several"distributions or sizes for different edges/boundaries to a meshing node to selectively control the meshing density

--
Good luck
Ivar
Hi check the doc on mesing, you also have the mesh refinement nodes in v4, just as you can add several"distributions or sizes for different edges/boundaries to a meshing node to selectively control the meshing density -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content