Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
How to add a sine source for current transformer modeling
Posted 09.09.2011, 15:30 GMT-4 Low-Frequency Electromagnetics Version 4.0a 3 Replies
Please login with a confirmed email address before reporting spam
Greetings,
I've been trying to model a current transformer but I'm unable to add an AC source to the model to simulate the behavior of alternating current on a wire and its magnetic effect on the transformer itself. I've already tried using the electrical circuit Physics model (which apparently only works on 2-D geometries) as well as the Frequency Domain analysis to apply this condition but so far I haven't had much success. I would really appreciate if anyone could provide any clue about the subject.
Thank you.
Jorge Benavides Aspiazu
I've been trying to model a current transformer but I'm unable to add an AC source to the model to simulate the behavior of alternating current on a wire and its magnetic effect on the transformer itself. I've already tried using the electrical circuit Physics model (which apparently only works on 2-D geometries) as well as the Frequency Domain analysis to apply this condition but so far I haven't had much success. I would really appreciate if anyone could provide any clue about the subject.
Thank you.
Jorge Benavides Aspiazu
3 Replies Last Post 31.03.2014, 14:25 GMT-4