Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Contact pairs
Posted 08.09.2011, 13:22 GMT-4 Heat Transfer & Phase Change Version 3.5a 2 Replies
Please login with a confirmed email address before reporting spam
Hi there,
I am trying to simulate conduction and convection heat transfer. Can I consider the fluid solid interaction boundary as a contact pair? [ As we now from comsol that we can consider the contact surfaces between two different solids as a pair.] After that from physics menu- boundary settings we can set the contact pair boundary condition as thin thermally resistive layer after that we can add thickness and layer thermal conductivity.
The question if that possible which thermal conductivity we should choose?
I hope my question is clear!
I am trying to simulate conduction and convection heat transfer. Can I consider the fluid solid interaction boundary as a contact pair? [ As we now from comsol that we can consider the contact surfaces between two different solids as a pair.] After that from physics menu- boundary settings we can set the contact pair boundary condition as thin thermally resistive layer after that we can add thickness and layer thermal conductivity.
The question if that possible which thermal conductivity we should choose?
I hope my question is clear!
2 Replies Last Post 09.09.2011, 03:40 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi I cannot remeber how it was in 3.5 but I beleive (do not have access to my COMSOl just now) that you can add a thin resisitve layer on internal boundaries in V4
--
Good luck
Ivar
--
Good luck
Ivar
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Thank you Ivar,
I had added that thin resistive layer and I've got results. One parameters of this thin resistive layer is thermal conductivity. Which thermal conductivity should I add, for liquid or fluid? I've tried both and the results are similar. Second in comsol documentaions pairs is used between two different contact solids, i.e., to mimic the small gap betweent solids due to surface roughness? My main question is: Is physically correct in COMSOL to use pairs to simulate the convection process occurs near solid boundary?
Thanks Ivar
I had added that thin resistive layer and I've got results. One parameters of this thin resistive layer is thermal conductivity. Which thermal conductivity should I add, for liquid or fluid? I've tried both and the results are similar. Second in comsol documentaions pairs is used between two different contact solids, i.e., to mimic the small gap betweent solids due to surface roughness? My main question is: Is physically correct in COMSOL to use pairs to simulate the convection process occurs near solid boundary?
Thanks Ivar