Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Stop simulations if strain is too large

Posted 31.08.2011, 05:56 GMT-4 Structural Mechanics Version 4.1 2 Replies

Jochen Müller
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hey there,

is there a way to stop the solver of my indentation simulation whenever the z-component of the stress tensor at a given point becomes too large? Do I have to define a variable and a probe at the given point? How can I make the solver stop the simulation?

Thanks for your replies and best wishes from Erlangen (Germany),

Jochen
2 Replies Last Post 31.08.2011, 10:40 GMT-4
Pasquale Franciosa
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 31.08.2011, 08:48 GMT-4
Hi,
you can use a parametric solver and then set a stopping condition (from solver configuration, add a parametri solver and then, by right clicking, add a stop condition).

Hope this help!

Pasquale

Hi, you can use a parametric solver and then set a stopping condition (from solver configuration, add a parametri solver and then, by right clicking, add a stop condition). Hope this help! Pasquale
Jochen Müller
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 31.08.2011, 10:40 GMT-4
Thanks a lot Pasquale. That should work ;)
Thanks a lot Pasquale. That should work ;)

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content