Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Shell and tube heat exchanger simulation problem
Posted 16.10.2018, 09:53 GMT-4 Fluid & Heat, Computational Fluid Dynamics (CFD), Mesh Version 5.3a 0 Replies
Please login with a confirmed email address before reporting spam
Dear all,
I'm simulating a heat exchanger with some of the tubes plugged within it.
I have 19 tubes within the heat exchanger.
When I 18 of 19 tubes, at different locations, I get the simulation done, But one of such cases is not getting siimulated.
I think that the boundary conditions are correct (as it gets simulated in other cases ).
Can you please take a look at the attached simulation?
thank you.
Attachments:
Hello Parag Patil
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.