Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Sweep over geometry parameter in Electromagnetics Module (V.4.2)
Posted 20.06.2011, 06:03 GMT-4 RF & Microwave Engineering, Geometry, Mesh Version 4.2 0 Replies
Please login with a confirmed email address before reporting spam
I am facing a problem with parameter sweeps. I want to calculate the extinction cross section of a particle for a given range of frequencies. Additionally, I want to sweep over a certain range of radii of the particle.
I tried using the Frequency Domain Study plus a Parametric Sweep over the radius, but that did not work properly. (The solver seems to take more steps, but the parameter is not displayed in the "Progress" tab during calculation). Then I discovered the "Auxiliary Sweep" in the "Frequency Domain Study Step" tab. Even though COMSOL says the parameter is swept, the geometry does not change for different values and the results are the same .
I suppose it could somehow be connected to what mesh and geometry the Study uses, but I did not find a way to change this. Could anyone give me a clue?
Best regards!
Christian
Hello Christian Matyssek
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.