Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Periodic pulsed heat load skip pulses irregularly

Please login with a confirmed email address before reporting spam

Hi,

I have been working on a simple comsol experiment to apply pulsed heat loads on a simple geometry which I eventually extend to a larger design.

I followed mainly the Laser heating of a weaver tutorial and everything works fine, however, when I look at my results my pulses are not periodic. (see picture) It skips a pulse at 1.5s and 5.5s.

My pulse train is 2 HZ, 100ms long and the period is 10s. I made an analytical function to make the pulsetrain. I have a explicit event to make sure I have enough resolution around the pulse. I thought it has something to do with my time depedent study, however, the position of the missing pulse remains while increasing sampling (I tried 0.1, 0.05, 0.01 and without specific time steps).

Where am I going wrong in this case? Thank you very much!



0 Replies Last Post 19.06.2018, 09:23 GMT-4
COMSOL Moderator

Hello Sjak Jansen

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.