Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

fluid mechanics - output to input

Posted 05.05.2011, 04:19 GMT-4 Fluid & Heat, Microfluidics Version 4.0 2 Replies

Carl Novak
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello

I hope someone can help me with the next problem. Im buliding a simple (3D) geometry of a square channel with input in the one end, and output at the other. My question is how would i put the output result of speed and concentration to the input of the next simulation of the channel of the same size. Basically i'm just trying to cut my model to individual regions and proces them seperatly.

Any help is appreciated, thanks.
2 Replies Last Post 16.02.2012, 13:37 GMT-5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 05.05.2011, 10:00 GMT-4
Hi

if you are in the same model file, you might use a coupling projection operator (check Definitions) or store the results and define initial conditions from there ...

--
Good luck
Ivar
Hi if you are in the same model file, you might use a coupling projection operator (check Definitions) or store the results and define initial conditions from there ... -- Good luck Ivar
jose tellez
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 16.02.2012, 13:37 GMT-5
Hi

I'm working with a similar problem , did you solve that problem of yours by any chance??. If you did could you please indicate me how?? . Thanks anyway
Hi I'm working with a similar problem , did you solve that problem of yours by any chance??. If you did could you please indicate me how?? . Thanks anyway

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content