Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Laminar Flow and Heat Transfer

Posted 23.03.2018, 03:47 GMT-4 Computational Fluid Dynamics (CFD) Version 5.2 1 Reply

Ankit
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

The below post is related to an archived discussion

Hello!

I am trying to model 3D laminar flow with heat transfer in a rectangular channel. I have coupled both the physics through the Multiphysics node. When I set the reference pressure pref as zero, I get the error message "Division by zero". As my model is not open to atmosphere, I do not want to keep the pref as 1[atm] (default value). Kindly provide your suggestions in this regard.

Thanks in advance.

1 Reply Last Post 23.03.2018, 08:02 GMT-4
Erik Bornhöft COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 7 years ago 23.03.2018, 08:02 GMT-4

Dear Ankit,

do you maybe use a pressure dependent gas density? You might get a zero density then. Set the reference pressure according to your conditions. If it is close to vacuum you might want to consider molecular flow instead of laminar flow.

See also: https://www.comsol.com/blogs/how-to-assign-fluid-pressure-in-cfd-simulations/

And: https://www.comsol.com/blogs/what-is-molecular-flow/

-------------------
Best regards,
Erik

*********************
Erik Bornhöft
COMSOL Germany
Dear Ankit, do you maybe use a pressure dependent gas density? You might get a zero density then. Set the reference pressure according to your conditions. If it is close to vacuum you might want to consider molecular flow instead of laminar flow. See also: https://www.comsol.com/blogs/how-to-assign-fluid-pressure-in-cfd-simulations/ And: https://www.comsol.com/blogs/what-is-molecular-flow/

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content