Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to simulate Squeeze Film Damping

Posted 16.04.2011, 14:52 GMT-4 Version 4.0a 2 Replies

Alec Yovanovitch
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I would like to use COMSOL to simulate the effects of squeeze film damping on an oscillating microcantilever in a closed body of fluid. Since the body is closed, the fluid displaced by the microcantilever as it moves down pushes on the top of the cantilever. Any ideas as to how I should go about this? What models to learn from, and what modules / settings I should use?

Thanks,
Alec
2 Replies Last Post 21.11.2016, 07:23 GMT-5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 16.04.2011, 15:26 GMT-4
Hi

you have an example model in the MEMS case of the Model library. It treats the squeezed film damping of a mems accelerometer plate. Take a look, its in 3.5 and at least in 4.1 so probably in 4.0 too. Anyhow I can only suggest that you find out how to upgrade to latest version, its far easier to use

--
Good luck
Ivar
Hi you have an example model in the MEMS case of the Model library. It treats the squeezed film damping of a mems accelerometer plate. Take a look, its in 3.5 and at least in 4.1 so probably in 4.0 too. Anyhow I can only suggest that you find out how to upgrade to latest version, its far easier to use -- Good luck Ivar
Anand Upadhyay
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 21.11.2016, 07:23 GMT-5

Hello Ivar,

As suggested we don't get model in model library for accelerator in version 5.0
Please tell some steps for squeeze film air damping in MEMS PZR Accelerometer.

regards,
anand
Hello Ivar, As suggested we don't get model in model library for accelerator in version 5.0 Please tell some steps for squeeze film air damping in MEMS PZR Accelerometer. regards, anand

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content