Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Swept Linking Face Problem Solutions
Posted 01.03.2018, 09:32 GMT-5 MEMS & Piezoelectric Devices, Geometry, Mesh Version 5.3a 1 Reply
Please login with a confirmed email address before reporting spam
I am currently having issues linking source faces to its destination face in the swept mesh. The Geometry I am using has a thin device design, and have successfully meshed the source face. When doing the sweep, a side face is currently sounding off an "Unsupported topology of linking face" error even though it is a simple extrude.
I am unsure how to debug this current issue to remove the problem as the geometry is a flat face that should have no topological complexity. The file size is larger than 5 MB and even through optimization I cannot attach it.
Hello Jeremy Brine
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
hi Jeremy,
I don't know if you still need the answer. But I think you shode partition the domain based on the neighbor domains. I have attached an example.
Bests, Mohammad
Attachments: