Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Form Assembly Problem
Posted 26.01.2018, 04:25 GMT-5 Low-Frequency Electromagnetics, Geometry Version 5.3 1 Reply
Please login with a confirmed email address before reporting spam
Hello,
i try to set up a 3D simulation of a rotating electrical machine. If i use a stationary study and the form union, everything is working fine and i get a solution. The opposite happens, if i use the form assembly (with imprints) and again only the stationary step. I always get an error, that the solution is not converging. But i need the form assembly for the time dependent step.
As i said, it is working with form union. What mistake am i doing? Can someone help me?
Attachments:
Hello Seb Pleb
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
I have a simillar problem. form Union works for a electrostatically actuaded cantilevers. But to analyse contacts I need form assembly, that is where I do not get results :(