Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Comsol 1D and 2D

Posted 29.12.2017, 16:03 GMT-5 1 Reply

hongwei liu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am simulating the mass and heat transfer in Comsol by using darcy law model and heat transfer in porous media model. It works for 1D modelling. But when I swith into 2D model by using the same parameters, Comsol has convergence problem.

1 Reply Last Post 30.12.2017, 18:57 GMT-5
Jim Freels mechanical side of nuclear engineering, multiphysics analysis, COMSOL specialist
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 7 years ago 30.12.2017, 18:57 GMT-5

It could be many issues. Without seeing your model, it is difficult to diagnose. It could be a meshing issue, boundary condition, any number of things could cause the problem.

-------------------
James D. Freels, Ph.D., P.E.
It could be many issues. Without seeing your model, it is difficult to diagnose. It could be a meshing issue, boundary condition, any number of things could cause the problem.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content