Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

The problem of Permanent Magnet Motor in 3D

Posted 17.12.2017, 22:45 GMT-5 Low-Frequency Electromagnetics Version 5.3 1 Reply

贵 胡
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I built the case geometry（Permanent Magnet Motor in 3D） into a complete geometry and solved it. Can anyone tell me why it does not converge? thanks！

But if I change the condition of the permanent magnet from Ampere's law to flux conservation, it would converge. What is the reason?

1 Reply Last Post 18.12.2017, 05:39 GMT-5
Siqi Li
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 7 years ago 18.12.2017, 05:39 GMT-5

hi, Not Converging can have a lot of reasons. Maybe because of the solvers, the mesh, or your physic models.

Regards, Siqi

hi, Not Converging can have a lot of reasons. Maybe because of the solvers, the mesh, or your physic models. Regards, Siqi

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content