Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

mass flow BC ( standard conditions)

Posted 29.11.2017, 11:14 GMT-5 Fluid & Heat, Heat Transfer & Phase Change, Computational Fluid Dynamics (CFD) Version 5.3 0 Replies

David Vieyra
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear all

My question is about the inlet Mass flow( Standard flow rate ; Standards defined by pressure and temperature) Boundary condition.

I have a pipe were it circulates 5 slpm of helium. This one is at 4 K. I would like to know how COMSOL does apply the pressure temperature correction to the mass flow real value. Cause if one is setting a standard flow measure as a fix value, how would it will traduce in to the real value flow??

also :

I have set Standard pressure as 1 [atm], and Standard Temperature as 293.5 [K]. Mean molar mass 4 [ g/mol] for helium.

Thank you.

0 Replies Last Post 29.11.2017, 11:14 GMT-5
COMSOL Moderator

Hello David Vieyra

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content