Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

CONTACT MODELLING

Posted 17.03.2011, 06:40 GMT-4 0 Replies

Giulio Ferrazzi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi everybody,

I´m solving with COMSOL 4.1 a 2D solid mechanics contact problem between two surfaces. Since one of them is three order of magnitude smaller, it´s impossible to find a parametric way (in fact the biggest surface is an ellix) to impose concact between them (the position x is the parameter that changes). Specifically I got always an error of approximation!

in order to find the right solution I need the two surfaces to be in perfect contact ... but at the same time the small one doesn´t have to penetrate in the big one a lot (fake resuts).

Is there a way in COMSOL to impose the perfect contact? (a point contact would be perfect, after that I can easily impose an offset to give a certain margin of contact to COMSOL)

Thanks
Giulio
0 Replies Last Post 17.03.2011, 06:40 GMT-4
COMSOL Moderator

Hello Giulio Ferrazzi

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content